Loaded forklifts must be driven with the load pointed up the ramp (good standard practice is to ALWAYS drive with the load pointed up the ramp or slope).
When operating a loaded forklift on a ramp or incline the operator should do what?
To properly operate a forklift on an incline, a driver must: Keep their eyes on the road at all times. Stay a safe distance from the edge of a ramp. Ensure the forks point downward.
What is the stability triangle of a forklift?
What is the stability triangle? Most counterbalanced forklifts have a three-point suspension system, meaning that the truck is supported at the two front wheels and the center of the steer axle. If you imagine all three points connected into a triangle, this is the forklift’s stability triangle.
When traveling up or down slopes How should the forklift forks be pointed?
How do you maintain control when traveling up or downhill?
- Loaded trucks, when travelling up and down hill that is greater than a 5% grade, should travel with the load pointed uphill.
- Unloaded truck should travel with the forks (load-engaging means) pointed down hill regardless of the grade.
How much back tilt should be applied when picking up a load?
When carrying a load on level ground, the correct position of the forks is 100-150mm (4-6 Inches) off the ground and tilted back sufficiently to stabilise the load.
How should you drive an unloaded lift truck on ramp?
What should you do to load (unload) vehicles using a forklift truck?
- Keep forks pointed downhill when traveling without a load on a ramp.
- Keep forks pointed uphill when traveling with a load on a ramp.
What is the correct way to travel on a ramp?
Requirements and Recommended Practices
- When traveling with a load, the load should point up the incline, regardless of direction of travel.
- Going up the incline: Drive forward. Forks pointed upgrade. Use a spotter if load blocks the driver’s view.
- Going down the incline: Drive in reverse. Turn head and face downgrade.
What are the three major points of the stability triangle?
The three points are the two front wheels and the pivot point of the rear axle. Connect the three points, and you have what’s called the stability triangle.
What direction must the load be in when going uphill?
Always drive straight forward when going uphill. So never drive uphill diagonally and never start turning on a slope. When loaded, the load must be in the highest position in relation to the slope (forwards uphill and backwards downhill).
What is the correct position when picking up a load?
Keep the load close to the waist. The load should be kept close to the body for as long as possible while lifting. Keep the heaviest side of the load next to the body. Adopt a stable position and make sure your feet are apart, with one leg slightly forward to maintain balance.
Which is the correct way to move a forklift?
You are operating a forklift that contains a full load and are traveling up an incline. You should: A. Travel backward B. Travel forward C. Travel forward at an angle
What’s the correct way to handle a load?
A. Move the load to one side so you can see around it B. Place the load at the highest position for traveling C. Place the load at the lowest position for traveling B. True (correct answer) Get OSHA 10 Exam Passed – Manual handling of materials accounts for the primary source of injury in the workplace. A. False
How to answer the OSHA 10 materials handling question?
Indicate whether the scenario below is safe or unsafe: You choose to store materials by stacking them in tiers, but do not secure them by stacking, racking, blocking, or interlocking them. A. Safe B. Unsafe C. Place the load at the lowest position for traveling (correct answer) Get OSHA 10 Exam Passed –
Which is true about manual handling of materials?
Manual handling of materials accounts for the primary source of injury in the workplace. A. False B. True B. True (correct answer) Get OSHA 10 Exam Passed –
